Amey trials gully sensors to prevent roads flooding
State-of-the-art sensors are being installed by Amey into gullies in a trial aimed at preventing the flooding of roads.
Excessive rainfall can lead to roads becoming flooded, especially if drains are blocked with silt and waste. Amey is, however, trialling a new approach in Hampshire that it hopes can avert these disruptive and potentially dangerous scenarios.
Currently, most local authorities inspect gullies (the drainage pits covered by an open metal grating located on the road edge) on a cyclic or risk-based basis. Although efforts might be focused on gullies that are known to be more prone to flooding, so far there has not been a method that allows councils and their contractors to understand in real time when a gully is getting blocked.
Amey is installing live sensors into gullies that will give data that will inform whether a gully is in need of a cleanse. These sensors measure the level of silt and the water level inside, feeding the information instantly back to a control centre managed by Amey via web-based, mapped, visualisation software.
This software couples weather forecasting with silt levels to inform if a gully is likely to flood over the next few days. A cleanse of that particular gully can then be instructed at a low cost, avoiding the need for subsequent emergency attendances. If the technology works well, then these gullies will only need to be cleansed when they are actually at risk of flooding, a more efficient and cost-effective approach.
Paul Anderson, account director at Amey, said: “This is exciting, new technology which should enable us to be much more proactive in terms of preventing gullies becoming flooded, as opposed to dealing with the issue in just a reactive way. We have installed 25 sensors in known ‘high risk’ gullies and are currently collecting information at these sites. If these sensors work as well as we hope they will, then it could lead to a radically different approach in Hampshire and elsewhere.”
Councillor Rob Humby, executive member for environment and transport at Hampshire County Council, said: “Heavy, intense rainfall can, as we all know, result in localised flooding, and keeping the water off the road surfaces is at the forefront of our highways work throughout the winter. These sensors should help us establish an inventory of each gully which will show us when and where we need to direct resources.”
- Trees planted in natural flood management pilot Hundreds of trees have been planted as part of the first project to trial natural flood management techniques to help... Read More >
- More planning applications held up by SuDS in England than Wales Planning applications are twice as likely to be blocked or delayed due to sustainable drainage system (SuDS) design in... Read More >
- MDS secures Affinity Water contract extension Morrison Data Services (MDS) has extended its meter data collection contract with Affinity Water by a further two years. Read More >
- Tyre microplastics pollution: Ignore it or remove it? Tyre microplastics is one of the largest sources of pervasive pollution in the water environment, yet consistently ignored... Read More >
- Meeting the SuDS challenge A report indicates that the UK has a long way to go on implementing sustainable drainage systems, yet advice and... Read More >
- Capital's infrastructure needs integrated water approach The concerns of Londoners about the capital city's resilience highlight the need for integrated planning across water,... Read More >
- Ready for anything: Resilience in the Round Resilience is one of the four priorities that Ofwat wants to see water companies adopt in their plans for PR19. But what... Read More >
- Moving towards greener resilience Nature-based solutions can help us to see the big picture when building in system resilience, writes Dr Jonathan Simm,... Read More >